Start with the dispenser you will actually supply
Record the model or give the holder your own project reference. Open it and measure the usable internal space, spindle arrangement and exit slot. A photograph of the outside is useful for identification, but it cannot show whether the roll has clearance inside the closed housing.
If your brand uses several holders, test each relevant model separately. A roll that turns freely in one housing may rub against a different lid, loading insert or spindle. Keep the holder reference beside the proposed roll reference rather than describing both as a universal fit.
Separate bag dimensions from finished roll dimensions
ReRoot’s catalogue reference 13-01 lists a 23 × 33 cm bag, 17 μm and 15 bags per roll. It does not establish a finished roll diameter or core size. Those are questions for the proposed configuration; they should not be inferred from the 15-bag count.
Ask whether the proposed sample uses a core or is coreless, and record how it is loaded. Request the finished roll width and outside diameter with the measurement points identified. If the reference sample differs from your intended thickness, winding or packing, ask what needs to be reviewed again.
Check the dispensing sequence before approving the pack
Load the roll, close the housing, locate the leading edge and remove the next bag in the expected direction. Observe whether the roll turns, whether film catches at the slot and whether the perforation separates without damaging usable bag space. Record what you did and where a problem occurred.
The number of samples and acceptance criteria should be agreed for the real project. This guide does not prescribe a laboratory test or claim that one successful pull proves production consistency. Keep any formal strength or leak testing as a separate, defined requirement.
Use a fault record rather than a general rejection
For example, a buyer may observe that a roll loads but stops turning after the lid closes. That observation points to a clearance or loading question; it does not by itself prove the film formulation is wrong. Photograph the loading arrangement and identify the sample so a revision can address the actual issue.
- Roll will not load: review roll envelope and spindle/core arrangement.
- Roll loads but rubs: review clearance with the lid closed.
- Bag tears before separation: review the perforation and feed path together.
- Retail pack count is unclear: separate bags per roll, rolls per pack and packs per carton.
Keep disposal claims separate from mechanical fit
A roll fitting a dispenser says nothing about compostability evidence or acceptance of pet waste. Follow the destination’s actual disposal instructions and request documents for the finished bag and proposed claim. Do not treat a dog bag as automatically suitable for a household food-waste program.
Send the holder reference, dimensions, roll questions, retail-pack counts and destination with your sample request. The dog waste bag page retains the original catalogue data.
Keep a Project Worksheet
Fill in the fields you know. Keep unanswered items as questions. This is a project worksheet, not a test certificate or an order approval.